ابو احميد
2014/02/25, 03:37 PM
In: serial
Out: serial
Err: serial
IdentID : 09 00 21 00 00 15 55
Hit ESC to stop autoboot: 3
Force command mode:Select boot (current boot system : spark):
1. spark(up key)
2. enigma2(down key)
3. RS232 Upgrade u-boot(left key)
4. Force into factory mode(right key)
Input Select:
Force Factory mode
(Re)start USB...
USB: scanning bus for devices... 2 USB Device(s) found
scanning bus for storage devices... 1 Storage Device(s) found
** Partition 1 not valid on device 0 **
** Unable to use usb 0:1 for fatload **
Warning: MAC addresses don't match:
HW MAC address: FF:FF:FF:FF:FF:FF
"ethaddr" value: 00:80:E1:12:06:38
Using MAC Address 00:80:E1:12:06:38
found phy at addres = 1
stmac_phy_get_addr(): id1 = 0x7, id2 = 0xc0f1
STM-GMAC: 100Mbs full duplex link detected
TFTP from server 192.168.40.19; our IP address is 192.168.40.63
Filename 'mImage'.
Load address: 0x80000000
Loading: T T #T
الجهاز لا يقبل الملفات لا من usb ولا من ftp
ue Feb 25 15:40:27 2014: Sending 'mImage' file to 192.168.40.63 in binary mode
Tue Feb 25 15:40:41 2014: Failed ( Timeout Error ).
Out: serial
Err: serial
IdentID : 09 00 21 00 00 15 55
Hit ESC to stop autoboot: 3
Force command mode:Select boot (current boot system : spark):
1. spark(up key)
2. enigma2(down key)
3. RS232 Upgrade u-boot(left key)
4. Force into factory mode(right key)
Input Select:
Force Factory mode
(Re)start USB...
USB: scanning bus for devices... 2 USB Device(s) found
scanning bus for storage devices... 1 Storage Device(s) found
** Partition 1 not valid on device 0 **
** Unable to use usb 0:1 for fatload **
Warning: MAC addresses don't match:
HW MAC address: FF:FF:FF:FF:FF:FF
"ethaddr" value: 00:80:E1:12:06:38
Using MAC Address 00:80:E1:12:06:38
found phy at addres = 1
stmac_phy_get_addr(): id1 = 0x7, id2 = 0xc0f1
STM-GMAC: 100Mbs full duplex link detected
TFTP from server 192.168.40.19; our IP address is 192.168.40.63
Filename 'mImage'.
Load address: 0x80000000
Loading: T T #T
الجهاز لا يقبل الملفات لا من usb ولا من ftp
ue Feb 25 15:40:27 2014: Sending 'mImage' file to 192.168.40.63 in binary mode
Tue Feb 25 15:40:41 2014: Failed ( Timeout Error ).